Wavetronix SmartSensor Advance Extended Range (SS-200E) - Use Manual do Utilizador descarregar pdf (Página 61)

60 CHAPTER 5  SENSOR SETTINGS

Note

If you are using a Click communication device, the baud rate for the sensor and the

Click device must be the same. Port 2 is designated as the data bus and is normally

left at 9600 bps in order to match the default setting on a Click 112/114 card. If you

change this baud rate on the sensor, you will also need to change it on the rack card.

 Response Delay – is is used to congure how long the sensor will wait before re-

sponding to a message received. is is useful for some communications devices that

are unable to quickly change transmission direction. e default value is 4 milliseconds

for ports 1 and 2.

 Remove Multi-drop Preﬁx – You will only need to turn this switch ON if you are using

a device that does NOT support the use of a multi-drop prex (i.e. Click 100).

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 147 148

Sem comentários

Wavetronix SmartSensor Advance Extended Range (SS-200E) - Use Manual do Utilizador Página 61