Wavetronix SmartSensor Advance Extended Range (SS-200E) - Use Manual do Utilizador descarregar pdf (Página 25)

24 CHAPTER 1  INSTALLING THE SMARTSENSOR ADVANCE

6 Tighten down the pan and tilt bolts, then tighten down the four bolts on the backplate.

If you are using the sensor on a curved road, you can aim the sensor so that it bisects the

curve of the road and still hits your nearest and farthest ranges of interest. If the sensor is

mounted near the outside edge of the curved road, you may be able to bisect the curve with

little or no roll. If the road curves dramatically, you may need to reduce the down tilt of the

sensor so that the beam fans out more at the far ranges.

Applying Silicon Dielectric Compound

1 Tear the tab o the tube of silicon dielectric compound.

2 Squeeze about 25% of the silicon into the connector at the base of the SmartSensor

Advance (see Figure 1.17).

3 Wipe o any excess compound.

Figure 1.17 – Connector Receptacle (left) and Grounding Lug (right)

Connecting the SmartSensor 6-conductor Cable

e next step is to plug the SmartSensor 6-conductor cable into the connector. e sensor

connector is keyed to ensure proper connection (see Figure 1.18); simply twist the plug end

of the connector clockwise until you hear it click into place.

Figure 1.18 – Sensor 6-conductor Cable Connector

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 147 148

Sem comentários

Wavetronix SmartSensor Advance Extended Range (SS-200E) - Use Manual do Utilizador Página 25