Wavetronix SmartSensor Advance Extended Range (SS-200E) - Use Manual do Utilizador descarregar pdf (Página 18)

CHAPTER 1  INSTALLING THE SMARTSENSOR ADVANCE 17

Main Shaft

Mount Head

Figure 1.1 – Mount Bracket

Before attaching the mount bracket to the pole, rst make sure that your cables are long

enough to support the sensor height and the distance from the sensor to the cabinet.

Follow the steps below to correctly attach the mount to the pole (see Figure 1.2):

1 Insert the stainless steel straps through the slots in the mount bracket.

2 Position the mount so that it facilitates visual line-of-sight from the sensor to the tar-

get. You will need to have sucient headroom behind the sensor to position your eye

behind the viewnder alignment tool (the next section will go into detail about the

viewnder alignment tool).

For a roadside installation (on a vertical pole) the mount's main sha can be positioned

slightly ahead of perpendicular to the roadway; you can then look from the side of

the pole. For an overhead installation (on a mast arm) the mount's main sha can be

positioned slightly above horizontal; you can then look over the pole (see Figure 1.2).

Height

Target

Distance

Oset (perpendicular)

Line-of-sight to target

Figure 1.2 – Pointing the Sensor

3 Tighten the strap screws (see Figure 1.3).

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 147 148

Sem comentários

Wavetronix SmartSensor Advance Extended Range (SS-200E) - Use Manual do Utilizador Página 18