Wavetronix VDR24 Radar Manual do Utilizador descarregar pdf (Página 46)

Power Up and User Interface Navigation

46 VDR24 Radar Detection System, Rev 1.0

7.3.4.3. Set Communication Parameters

The first step before connecting to one of the radar

sensors is to set the serial communication port used

by the SSM-Rail application. Depending on the

computer being used it may be easiest to select

AutoDetect.

The Internet selection tab is used when there is an

Ethernet-based connection to the configuration

application. The Virtual selection tab is used for

simulating detections utilizing recorded emissions.

This is primarily used for training purposes of for Island

radar engineers to evaluate specific installation

behavior. Most users will utilize the RS-232 serial port

for configuring radar sensors.

1. Select the Serial Tab

2. Select the port being used by the SSM-Rail

application. AutoDetect may also be used on

some computers

1. Set the timeout parameter to 1000ms (nominal

setting)

7.3.4.4. Search the Radar Network for the Radar Sensor to be Configured

The Search control is used to discover and catalog all

radar sensors connected to a specific VDR24.

Sensors are then chosen individually for connection

and configuration.

1. When activating a system for the first time,

select Full as the search method. This allows

the SSM-Rail application to resolve any

address conflicts on its own when organizing

radar sensors connected to the VDR24.

Afterwards, the Quick search method may be

used.

2. Select Search to list radars connected to the

VDR24

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 77 78

Sem comentários

Wavetronix VDR24 Radar Manual do Utilizador Página 46