Wavetronix SmartSensor HD (101-0415) - User Guide Manual do Utilizador descarregar pdf (Página 44)

CHAPTER 4  COMMUNICATION 43

1 Make sure that all power and communication wiring is correct.

2 Check the port settings (baud rate, port ID).

3 Make sure that the sensor ID is correct.

Connection failure can occur for various reasons; if a failure occurs repeatedly, call Wa-

vetronix Technical Services at 801-764-0277 for assistance.

Installation Type

Once the communication parameters are selected, choose the installation type to be used

for the connection.

Connecting to an Isolated Sensor

is protocol option is recommended when only one sensor exists on the remote end of the

connection (see Figure 4.7).

Figure 4.7 – Isolated Sensor

Connecting to a Sensor in a Multi-drop Network

Connecting to a sensor in a multi-drop network is recommended when more than one

sensor exists on the remote end of a connection. To connect to a sensor on a multi-drop

network, select Multi-drop Network from the drop-down list and enter the multi-drop

sensor ID of the sensor you are connecting to (see Figure 4.8).

Figure 4.8 – Multi-drop Network

If you do not know the sensor ID, click on the sensor and magnifying glass at the end of the

Sensor ID eld to do a search for all sensors on the serial bus.

Communication Screen Icons

At the bottom of the serial and Internet connection screens there is a white bar with icons.

is section will explain the purpose of those icons.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 88 89

Sem comentários

Wavetronix SmartSensor HD (101-0415) - User Guide Manual do Utilizador Página 44