Wavetronix SmartSensor 105 (SS-105) - User Guide Manual do Utilizador descarregar pdf (Página 72)

CHAPTER 6  LANE SETUP 71

cancel your changes, click Cancel and Refresh. Clicking Refresh button will restore

the current interval length.

2 Synchronize the sensor time to your computer’s UTC time. is will ensure that inter-

vals will begin and end at the expected time. Intervals are timestamped at the end of

the interval. To synchronize the sensor time, click the Synchronize icon, which shows

two overlapping clocks.

e other two icons near the bottom of the page are for logging data:

 Turn Interval Data Logging On/O – Turns event logging on and o. Click on the icon

(it shows a clock and light switch) to toggle the switch on and o. Once you’ve turned

it on, you will be prompted to create a new log le if there is not already an existing

one. Now all of the data shown on the screen will be written to a standard text le that

can be viewed at any time.

 View Interval Data Log – Opens the log le in a text editor such as Notepad (see Fig-

ure 6.12). e icon shows a clock and paper.

Figure 6.12 – Interval Data Log

e interval data in the Interval Data Screen is displayed in a table that contains the lane

name, volume, speed, occupancy, and class. e lane at the top of the table is the lane closest to

the sensor. At the bottom of the screen is a status bar that indicates the time the interval data

table was last updated. It also displays the amount of time that has elapsed since this update.

 Lane Name – Displays the string of eight alphanumeric characters that describes the

lane.

 Volume – Shows the number of events during the interval.

 Interval Lane Speed – Represents the average speed of the lane during the time of the

interval. e speed is displayed either in miles per hour (mph) or kilometers per hour

(kph), depending on your settings.

 Occupancy – Displays the percentage of time vehicles occupied the sensor’s detection

zone during the selected interval.

 Class – Represents the percentage of vehicles detected as tting in one of three length-

based classication groupings (Small, Medium, and Large).

Note

To open data logs from anywhere in the SmartSensor Manager program, go to File

> Data Logs . . . > Open and select the type of log. This will open the most recently

used log.

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 98 99

Sem comentários

Wavetronix SmartSensor 105 (SS-105) - User Guide Manual do Utilizador Página 72