Wavetronix SMARTSENSOR 105 Guia do Utilizador descarregar pdf (Página 55)

54 CHAPTER 5  COMMUNICATION

Note

A quick search should not be used the ﬁrst time you connect to sensors on an

RS-485 control bus. If you add or replace a sensor on an existing control bus, a full

search will need to be performed before a quick search can be made.

Note

If you perform a full search and then cancel before the search is complete, the sen-

sors not discovered before the full search was terminated will also not be visible af-

ter a quick search. You will then need to perform a full search to completion before

all sensors can be discovered using a quick search.

5 Click the Search button.

6 Click on the desired sensor row from the list to select a sensor (see Figure 5.4). e

sensor list shows the sensor ID, location, and approach of each discovered sensor.

7 Click the Connect button. You will be directed back to the home page once a connec-

tion is established.

Figure 5.4 – Serial Connection

After you have connected to a sensor, the next time you would like to connect you

can simply click the magnifying glass icon in the upper right corner of the screen.

is will take you to the last connection settings you used to connect to a sensor.

e rst time you connect to a sensor, the default Sensor ID will be the last seven digits of

the sensor’s serial number. However, the names in the Location and Approach elds will

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 106 107

Sem comentários

Wavetronix SMARTSENSOR 105 Guia do Utilizador Página 55